When only a code is allowed to reset, programme for [Reset Code Only]. Aritech reserves the right to change specifications without notice. In this case the exterior bell follows the A Alarm. Use from 4 up to 6 digits with the exception of ‘0’. Reconnect the wires back to the panel and retest.

Uploader: Akinok
Date Added: 8 February 2008
File Size: 62.70 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 27656
Price: Free* [*Free Regsitration Required]

The exterior bell and Perimeter bell output types will reset after this time alarm expired. Zone Attributes Zone Type4. Now accept [] to leave the Engineer Programming Mode. Ps part set of system. During the entry procedure the entry timeris started which allows disarming. When set to ’99’ code 4 is always operational. Fire Input aritech cs350 manual 24Hrs operational.

Setting to ‘0’ disables the code. Exremely useful with inertia shock aritech cs350 manual. This section is dedicated to providing you with easy access to comprehensive information about the Aritech Documents. Disconnect the alarm zone wires from the terminal block aritech cs350 manual replace with display when attempta 4K7 resistor.

  ELLIOTT YAMIN WAIT FOR YOU INSTRUMENTAL FREE DOWNLOAD

Check that jumper is on link LK1 on the main control panel. Only after the additional entry time expired, which is half the time programmed in 2. Digital communicator fault input Any combination of the above wiring methods is allowed with the restriction that the total cable length on each of the wiring loops either multidrop or star is restricted to m. New perimeter system capability which provides local alarms for perimeter zone activations.

Confirm changes to the description shown on the display after programming. Each time the system is powered down the panel memorizes it’s current state, i. Check that the ‘In’ attribute is set for this zone number ‘Zone Attribute’ in ‘Zones’ menu. When only the zone attributes Ls is addedthen the panel will cause a local alarm for inertia sensor activations and a full alarm when the window opens. Keypad 3Keypad 4Figure 4.

Confirm to reprogram current text. The related input will not activate any alarm output but only log its events. Will return to its programmed status when you move to the next output.

  THE COWBOY AND THE ANGEL BY LIETHA WARDS FREE DOWNLOAD

The Display will prompt for the Language Default prefered. Check if zone c350 not in soak test ‘Zones Menu’ at ‘Zone Attributes’. Check that the battery is connected correctly.

Aritech CS350 Manuals & User Guides

Factory default code for user code01is []. Keyswitch partially arms system. Check wiring to the keypad, especially for swapped wires.

Entry time 30 sec. Resets with disarm or start of entry time. Input s and code s must have the ‘In’ attribute to be able to force arming of the panel.

Aritech CS Installation Instructions

The input is automatically bypassed after an alarm till the second entry manuxl a valid user code. Exit The exit time stops and system arms 4 seconds after Terminator closing the input. Check that the battery fuse is not blown.